Rated 5 out of 5Â by Mikey1977 Jig saw blades
Great blades would defo buy again. Worked well managed to cut every plank with out any hardship 10 boxes and still going.
10 Oct 2016
Rated 2 out of 5Â by Boxsectionbob Not impressed
Used to cut a 15mm thick laminate/ chipboard. Chipped laminate on both sides. Blade is narrow and not stiff enough to support blade length. Blade got half way through 18" cut and started to wander, even though guide rails used to get straight cut. Perpendicularly at half stage went out too.
26 May 2016
Rated 5 out of 5Â by VanMonkey Great Blades
Use them to cut 15mm Laminated ply, they do an excellent job!
9 Dec 2015
Rated 5 out of 5Â by piglet Excellent blade for laminates
This is a Swiss-made Bosch blade with no set to teeth.
Cuts a fine almost chip-free line right down to 10-15 mm diameter curves.
Use a masking tape over the surface to stop jigsaw foot from marking and help prevent breakout - don't use too much pendulum action.
A couple of reviwers commented about breaking etc. - the Bosch spec states 10-15 mm max depth of cut - if you try with a 38-mm worktop full of rubbish chipboard of couse it's going to break and bend - for something like a sink cutout use a much sturdier blade - common sense.
16 Nov 2015