0500 41 41 41
Cookie Reports - Screwfix Cookie Policy
Google Chrome Firefox Internet Explorer 8+


Air Impact Wrench ½"

Product Code: 75588

Rated 2.6 out of 5 by 5 reviewers.

Superior power-to-weight ratio. Rocking dog clutch mechanism for smooth power delivery.

View more information

Product contents:
125mm extension bar, 10 x ½" dr sockets: 9, 10, 11, 13, 14, 17, 19, 22, 24 and 27mm, 4mm spanner, oiler and ¼" PT European type male nipple.

No load speed, 7000rpm. Average air consumption 25%, 4scfm. Max. torque, 230ft/lbs. Air pressure 90psi (6bar). Requires 2hp/50Ltr compressor.

£39.99 (inc. 20% VAT)

2.6 5 5

Add to saved list

Available for deliveryNext Day Delivery
Available for collection from store Store Collection Check stock in your store
Page 1 of 4
Rated 1 out of 5 by Low efficency On the plus side the impact gun was cheep... It needs a lot of pressure to get it to work properly. This gun is 1/2 drive and does offer quick removal after you loosen the bolt/ nut. My advice is to save your money and buy either the Ingersol Rand or snap-on impact as they are the ones to use on tight bolts. 6 Sep 2014
Rated 4 out of 5 by Air Impact Wrench Better value than I thought! Description does not include the fact that it comes in a case with a set of sockets and extension. Held up fixing my car, quick and easy order on line and ready to collect when I walked in. Wrench does what it says on the tin, 23 Jun 2014
Rated 5 out of 5 by Excellent Product Superb Value Bought specifically to remove 230NM crank pulley bolt, straight off no messing in 5 seconds flat, didn't even need to make a flywheel locking tool - put car in gear, wedged front hub, that was enough. Re-tightening torque when checked with torque bar read over 230NM, so it tightens plenty too. I'd advise connecting straight to compressor tank, remove all your dryers, regulators etc so it gets a full 150psi, if your compressor maxes out at 8 bar you will not be able to unleash the power of this wrench. Also ensure the 4-position control on the wrench is set to maximum Inexplicably the product description fails to mention you also get a carry case, oil reservoir, impact sockets 9, 11, 13, 17, 19, 22, 24, 27mm and short extn bar. i also needed 74700 male 0.25in BSP connectors. The leaking air mentioned above; yes it does come past the direction reversal pin as well as from the proper exhaust outlet but this is simply the exhausted gas exiting the front of the drill once it has done its job driving the vane motor. Only slight downside the finger trigger is plastic not metal, so a careless drop onto a concrete floor might break it. Highly recommended but your compressor needs to be up to the job otherwise i can only imagine it being useful for spinning wheel nuts etc. 9 Sep 2013
Rated 1 out of 5 by Junk! Leaks air has NO torque. Rubbish! Even at 8 bar it still had no performance. 15 Dec 2011
Page : 2 next>


Manufacturer Guarantee 1 years
Manufacturing Standards CE & GS
Pack Size 1
Total Product Weight 4820 kg